globus  Worldwide shipping from Germany - free from 50

Remote control CD 204

In order not to lack a little comfort, a remote control module in the CD 204 can be used very quickly.From the ready-equipped remote control board, the cables that are plugged into the board have to be soldered to the CD player. The remote board is insulated with a transparent plastic for isolating and can later easily be inserted into the housing.

Remote control for Philips CD204 48buy

remote control  philips cd204

Remove the upper housing cover. The front of the device is attached to the top and bottom with 3 screws each.

philips cd204 inside

After these are solved, the two cable strands can be removed at the connectors of the now loose front panel. The removal of the front panel is as easy as the entire installation of the remote control module.

cd204 front pcb

The 10 solder points for the cables of the remote control module are freely accessible.

wiring remote philips cd204

Simply push the remote control module into the gap between the front panel and the zinc casting basket of the main housing. Now only the receiver for the infrared signal has to be attached. For this purpose, the position of the headphone output is useful. The IR receiver can be easily attached with some hot glue. So there is no hole for the IR receiver to be drilled.

infrared receiver philips cd204

Barely visible, the receiver sits in the middle of the front panel. Alternatively, the IR receiver can also be mounted under the front panel as with the CD 100/101 .